B-003-01: Functional layout of HF stations
B-003-01-01:
A low pass filter in an HF station is most effective when connected:
as close as possible to the transceiver output
as close as possible to the antenna tuner output
as close as possible to the antenna
midway between the transceiver and antenna
B-003-01-02:
A low pass filter in an HF station is most effective when connected:
as close as possible to the linear amplifier output
as close as possible to the antenna
as close as possible to the antenna tuner output
as close as possible to the linear amplifier input
B-003-01-03:
In designing an HF station, which component would you use to reduce the effects of harmonic radiation?
Low pass filter
Dummy load
Antenna switch
SWR bridge
B-003-01-04:
Which component in an HF station is the most useful for determining the effectiveness of the antenna system?
SWR bridge
Antenna switch
Linear amplifier
Dummy load
B-003-01-05:
Of the components in an HF station, which component would normally be connected closest to the antenna, antenna tuner and dummy load?
Antenna switch
Transceiver
Low pass filter
SWR bridge
B-003-01-06:
Of the components in an HF station, which component would be used to match impedances between the transceiver and antenna?
Antenna tuner
Antenna switch
Dummy load
SWR bridge
B-003-01-07:
In an HF station, which component is temporarily connected in the tuning process?
Dummy load
SWR bridge
Low pass filter
Antenna tuner
B-003-01-08:
In an HF station, the antenna tuner is usually used for matching the transceiver with:
most antennas when operating below 14 MHz
most antennas when operating above 14 MHz
mono-band Yagi type antennas
tri-band Yagi antennas
B-003-01-09:
In an HF Station, the antenna tuner is commonly used:
with most antennas when operating below 14 MHz
with most antennas when operating above 14 MHz
to tune into dummy loads
to tune low pass filters
|
Color key:
|
|
● = Unseen
|
|
● = Weak
|
|
● = Review
|
|
● = Learned
|
|
● = Incorrect answer
|
